Barix100 firmware update on M1 Mini.

[Brian Williams]

Hi Bill V,

I'm not sure what the question is, but I run 3 Barionet 100 devices. Recently, I ran into some external hardware issues, and took the opportunity to update the B100 firmware, and some ancillary firmware to support the communications with an IO12 and an R6. 

All of this was provided through my M1 Mac mini Safari browser and Terminal, following the directions from Barix. The only issue that I met was forgetting to specify the file type when putting the cob file to the Barionet (using Terminal). I don't think there was anything written about that, and I cannot remember at the moment, but given that warning, you will no doubt succeed.

Best regards and good luck.

Brian