supported_hardware:hubitat
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
supported_hardware:hubitat [2021/02/02 15:05] – [Using The Hubitat Plugin:] added device notifications James Sentman | supported_hardware:hubitat [2021/02/09 14:34] – James Sentman | ||
---|---|---|---|
Line 1: | Line 1: | ||
=====Hubitat===== | =====Hubitat===== | ||
{{: | {{: | ||
- | The [[https:// | + | (v1.2) |
Line 35: | Line 35: | ||
Enter the API ID and Access Token from the URL's in the MakerAPI setup screen into the next section. | Enter the API ID and Access Token from the URL's in the MakerAPI setup screen into the next section. | ||
+ | |||
+ | The **Scan For New Devices Now** button will be enabled if the plugin interface is running and will perform a deep database scan when you click it. If you add new devices to the MakerAPI sharing list you can make them show up in XTension immediately by clicking that button. A deep scan is run every 5 minutes, this button runs it on demand. | ||
Click the Save button to save the Hubitat plugin instance in XTension. You can then enable the plugin in the Interfaces list window. | Click the Save button to save the Hubitat plugin instance in XTension. You can then enable the plugin in the Interfaces list window. | ||
Line 98: | Line 100: | ||
Please make your desire for this to them via feature requests or posts on their community support boards! | Please make your desire for this to them via feature requests or posts on their community support boards! | ||
+ | ====Potential Issues:==== | ||
+ | * I cannot currently get my Hubitat to recognize some older ZWave 1 switches. They can be added only as a “Device” and are not controllable. Changing the device type in the Hubitat to a generic dimmer or switch does show the rest of the controls but they cannot be successfully controlled. | ||
+ | * As of this moment only click and double click and click and hold appear to be able to captured to the central scene handler. Many switches support more than that. This appears to be a limitation in the MakerAPI as of this writing. | ||
+ | * The enumerations for things like Thermostat Modes are different than the Vera. To avoid confusion you should script them via the newer [[dictionary: | ||
+ | <code AppleScript> | ||
+ | set value of “Thermostat Mode Unit” to “cool” | ||
+ | </ | ||
====History: | ====History: | ||
* The Hubitat plugin was first added as a beta version in XTension v9.4.35 in January of 2021 | * The Hubitat plugin was first added as a beta version in XTension v9.4.35 in January of 2021 | ||
- | * Thermostats are working as of version 9.4.36 | + | * Thermostats are working as of XTension |
+ | * Ceiling Fan control is working as of XTension version 9.4.37 plugin version 1.2 |
supported_hardware/hubitat.txt · Last modified: 2023/11/04 13:49 by James Sentman