supported_hardware:hubitat
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| supported_hardware:hubitat [2021/02/02 15:05] – [Using The Hubitat Plugin:] added device notifications James Sentman | supported_hardware:hubitat [2021/02/09 14:27] – [XTension Settings:] added scan for new devices button James Sentman | ||
|---|---|---|---|
| Line 35: | Line 35: | ||
| Enter the API ID and Access Token from the URL's in the MakerAPI setup screen into the next section. | Enter the API ID and Access Token from the URL's in the MakerAPI setup screen into the next section. | ||
| + | |||
| + | The **Scan For New Devices Now** button will be enabled if the plugin interface is running and will perform a deep database scan when you click it. If you add new devices to the MakerAPI sharing list you can make them show up in XTension immediately by clicking that button. A deep scan is run every 5 minutes, this button runs it on demand. | ||
| Click the Save button to save the Hubitat plugin instance in XTension. You can then enable the plugin in the Interfaces list window. | Click the Save button to save the Hubitat plugin instance in XTension. You can then enable the plugin in the Interfaces list window. | ||
supported_hardware/hubitat.txt · Last modified: 2023/11/04 13:49 by James Sentman