Differences

This shows you the differences between two versions of the page.

--- supported_hardware:controlbywebout [2022/12/25 16:23] – added important safety tip James Sentman
+++ supported_hardware:controlbywebout [2023/02/13 14:52] (current) – external edit 127.0.0.1
@@ Line 9: / Line 9: @@
 ====Important Safety Tip:====
-Do not set the web interface port number to the same as the port number for the interdevice communication protocol or both will be rendered useless and you will have to do a factory reset on the controller in order to get it working again.
+Do not set the web interface port number to the same as the port number for the Remote Services protocol or both will be rendered useless until you do a factory reset on the controller.
 ====Plugin Settings:====
@@ Line 28: / Line 28: @@
 ====Managing Units To Ignore:====
-By default some known keys are ignored by XTension as they cannot be easily converted into a unit value for example the time or latitude that the device also sends. There may be more keys that do not translate in newer or more complex systems that also need to be ignored. Or you can use the same procedure to tell it to ignore the voltage input unit which tends to create a lot of traffic as it bounces around. This is done via the following scripting commands:
+By default some known keys are ignored by XTension as they cannot be easily converted into a unit value for example the time or latitude that the device also sends. There may be more keys that do not translate in newer or more complex systems that also need to be ignored. Or you can use the same procedure to tell it to ignore the voltage input unit which tends to create a lot of traffic as it bounces around. Note that capitalization matters when adding keys to the list so please do a Log Next Polling Result from the setup dialog before adding things to make sure you get the capitalization correct.
+This is done via the following scripting commands: