=====Home Seer FC200 Fan Controller=====
{{:supported_modules:fc200.jpeg?300 |}} The Home Seer FC200 ZWave Plus fan controller is capable of 4 fan speeds and all the same gesture information as the [[supported_modules:hs-wd200|WD200+ dimmer]]. You can also individually control the color of it’s 4 LED’s. See that article for more info on capturing the central scene output and setting the colors of the LED’s


By default the FC200 ships with only 3 fan speeds as that seems to be the default for other devices. You can turn on the 4 speeds by issuing this command from XTension’s command line:

<code>
tell xUnit “name of the fan controller unit” to setData( 5, 1, 1)
</code>
or setData( 5, 1, 0) to set it back to 3 speed mode.

Another nice feature of this speed controller is that the max amps of the fans is 2.5 amps. This is higher than some other fan speed controllers I have used. If you’re maxing that out for multiple fans then you may find the low speed a little comical and you’re going to want to definitely enable the 4 speeds so you can get a decent medium speed out of it.


====ZWave Paramters====
This table is reproduced from the documentation for the switch available on the HomeSeer site. Please verify that your controller is of a firmware version that is compatible with this information before using the [[dictionary:unitcontrol:setdata|setData]] command or at the very least it will do nothing and at the worst you could brick your switch.

^Parameter^Description^Bytes^Value^Default^
|3|Sets the bottom LED operation (in normal mode)|1|0=Bottom LED ON if load is OFF, 1=Bottom LED OFF is load is OFF|1|
|4|Set switch orientation|1|0=normal paddle direction, 1=inverted paddle orientation|0|
|5|Changes between 3 or 4 speed control|1|0=3 Speeds, 1=4 Speeds|0|
|13|LED Indicator Mode|1|0=Normal (leds show load status or speed), 1=status mode (individual LED Control)|0|
|14|LED Color while in normal mode|1|valid values from 0-6. 0=White, 1=Red, 2=Green, 3=Blue, 4=Magenta, 5=Yellow, 6=Cyan|0|
|21|Status Mode Color for LED 1(bottom)|1|valid values 0-7. 0=Off, 1=Red, 2=Green, 3=Blue, 4=Magenta, 5=Yello, 6=Cyan|0|
|22|Status Mode Color for LED 2|:::|:::|:::|
|23|Status Mode Color for LED 3|:::|:::|:::|
|24|Status Mode Color for LED 4|:::|:::|:::|
|30|Blink frequency for ALL Leds in Status Mode|1|valid values 0, 1-255. 0=Steady, 1=100ms ON then 100ms OFF|0|
|31|Bitmask to set which LED’s to blink|1|bit0=LED 1, bit1=LED 2, bit2=LED 3, bit3=LED 4|0|