supported_hardware:radiora2
Differences
This shows you the differences between two versions of the page.
Last revisionBoth sides next revision | |||
supported_hardware:radiora2 [2019/02/21 17:19] – created James Sentman | supported_hardware:radiora2 [2019/02/21 17:22] – [Output] James Sentman | ||
---|---|---|---|
Line 22: | Line 22: | ||
===Output=== | ===Output=== | ||
- | Most devices you will want to control can be setup as a generic “Output” type. In this case the Unit address will correspond to the Integration ID that was assigned in the Hub. If you created the unit by physically controlling the switch then the address will already be filled in. After creating | + | Most devices you will want to control can be setup as a generic “Output” type. In this case the Unit address will correspond to the Integration ID that was assigned in the Hub. If you created the unit by physically controlling the switch then the address will already be filled in. Once the unit is created you can set the dimmable property if the device is a dimmer. |
Output devices support the “rate” parameter to the [[dictionary: | Output devices support the “rate” parameter to the [[dictionary: |
supported_hardware/radiora2.txt · Last modified: 2023/02/13 14:52 by 127.0.0.1