supported_hardware:cm19
This is an old revision of the document!
CM19
NOTE: The CM19 interface is no longer made and will not be supported in XTension versions running on Catalina or newer OS versions. CM19 support is officially deprecated in XTension but will continue to work on OS versions prior to Catalina.
- Since the device does not implement a serial number in it's USB implementation only a single one can be connected to XTension at a time.
- XTension supports both receiving of wireless X10 (remotes and motion sensors only, this device does not receive security devices) and the transmitting of X10 wireless and ninja camera mount remote control.
- CM19 support is built into XTension and does not require any additional plugins or licenses.
- The picture to the right shows the CM19 as mounted in my data closet and altered by the replacement of the rat tail antenna with a coax connector. The device ships with a loose wire antenna that can be replaced with a coax connection very similarly to the MR26 with a coax connector for better range. Instructions can be found here on the shed.com site. for those who are more concerned with their reception than their warranty.
supported_hardware/cm19.1598361361.txt.gz · Last modified: 2023/02/13 14:51 (external edit)