XTension 9.4.45 Beta 2 (important to do some testing!)

[Dave Fleck]

Testing testing 1,2,3

I’ve been running the beta for over a week now on an M1 running 12.1 and everything seems fine. The only new problem I saw was on first install of the beta. I quit XTension normally and copied the beta into place but when the beta started it gave me an “XTension wasn’t shut down properly” error on startup. It has not happen on start since then.

I had not setup the Calendar interface in the past. Just to try it out I set it up and added a unit. I get the following error (which might be my fault?):
Calendar: error in CalDav Process: can't compare offset-naive and offset-aware datetimes (Calendar)

Some other errors existing prior to this beta:
* If I turn on debug for an interface while it is disabled, then enable the interface, the state of the debug checkbox is reversed (on when not checked, off when checked). This was on the CM11a interface.
* MySensors sensor types numbered 51 and above are not recognized.
* Command W doesn’t close the Alien Devices window.
* XTension Kits is not closing properly on quit. I think it might be leaving a port open.
* Numbers aren’t sorted correctly. It looks like they are sorted alphabetically.

Hope this is helpful.

Cheers,
Dave

----------
"I always find it more difficult to say the things I mean than the things I don't." -- W. Somerset Maugham