monnit

[Charlie Pendleton]

This was the one I was eyeing up: https://www.controlbyweb.com/accessories/wall-mount-temp-humidity-sensor.html

It says “digital 1-wire interface"

Best,
Charlie-
On Feb 11, 2021, 5:39 AM -0500, James Sentman <james at sentman.com>, wrote:
> I don’t think I was aware there was a temp/humidity sensor that was also 1-wire. If it’s just a 1-wire temp sensor then it will work. If it’s a temp/humidity sensor then it’s probably something custom that wouldn’t work with my 1-wire board or the Barix.
>
> That being said the current firmware for my 1-wire devices can also hang a DHT22 sensor off the gpio line that is on the board inside the case. So it can also measure temp and humidity. You can only attach one of those though you can still have up to the 16 1-wire sensors at the same time.
>
> If the device isn’t picking up the new firmware release I can send anyone a direct download for that. You’d know if you didn’t have it if the settings page doesn’t have an entry to select what is on the GPIO line.
>
> > On Feb 10, 2021, at 4:11 PM, Charlie Pendleton <charlie at pendletonweb.com> wrote:
> >
> > Do you think the ControlByWeb sensors (which seem to be 1-wire, would pair up with your 1-wire bus or that on the Barionets? They have a nice looking wall-mount temp/humidity sensor. Just wondering out loud...
> >
>
> Thanks,
>  James
>
>
> James Sentman                       http://www.PlanetaryGear.org http://MacHomeAutomation.com
>
>
>
>
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.machomeautomation.com/pipermail/xtensionlist/attachments/20210211/413022b1/attachment.html>