Vera with Aeotec smart switch - SS6 Version 1.03 required

[Ed]

The version I have is 1.04, I believe. At least the last two numbers in 
the version are 1,4.

So I got a suggestion back from Aeotec support. I now have two new 
entries in XTension: Aeotec (kwh) and Aeotec(watts). Wowever, I'm not so 
sure that following the suggestions from the Aeotec guy is what did the 
trick. I just started fooling around with the options menu a and 
configuration menu and voila!

Now the problem is that even though there are new power units and a new 
read-out in the Vera web interface for watts, it only ever reads 0 
Watts. Maybe I need a bigger load than a soldering iron?

Can someone explain the use of parameters 90, 91 and 92, please? I think 
when I changed parameter 90 to <blank> is what triggered the appearance 
of the two power units. Kind of counter-intuitive, actually...

Ed


On 1/28/19 12:44 PM, Ryan McLean wrote:
> I went through this song and dance about 4 weeks ago, so late 
> December. I was given the choice of 1.03 or 1.06. I believe I loaded 
> the 1.06 and all has been fine.
>
>
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.machomeautomation.com/pipermail/xtensionlist/attachments/20190128/bf340051/attachment.html>