Vera Re-pair Device?

[Thomas Arman]

FYI, I never reboot Vera.  I “reload”, much faster and seems to clean things up when I make changes. 
Tom

--------------------

> On Jan 19, 2019, at 8:57 PM, Tom Yarmas <tom at yarmas.com> wrote:
> 
> I guess you can turn debug on the Vera interface and see if there are more details. I have seen this in the past and have tried disabling and re-enabling the vera interface in Xtension. I have also had to reboot the Vera at times to get it to create units some times.
> 
> Not sure why this happens. I think it may be best to disable the Vera interface while you add the device to the Vera, then enable the interface and it seems to be cleaner. 
> 
> -tom
> 
>> On Jan 19, 2019, at 8:29 PM, KC Hundere <khundere at gmail.com> wrote:
>> 
>> Two questions:
>> 
>> I had a Z-wave device without power for a couple of weeks, and when I turned it back on, it was no longer connected to the Vera Plus.  Is there a way to reconnect this device without deleting  and recreating it from scratch?
>> 
>> So I recreated it on the vera, but it does not show up in Xtension but generates the error:
>> 
>> 1/19/19 6:18:07 PM  Vera: not creating a unit for device type (none) at address 106 (Vera)
>> 1/19/19 6:18:08 PM  Vera: not creating a unit for device type (none) at address 106 (Vera)
>> 1/19/19 6:18:09 PM  Vera: not creating a unit for device type (none) at address 106 (Vera)
>> 1/19/19 6:18:09 PM  Vera: not creating a unit for device type (none) at address 106 (Vera)
>> 
>> (It used to be Device 102)
>> -- 
>> KC Hundere
>> _______________________________________________
>> XTensionList mailing list
>> XTensionList at machomeautomation.com
>> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist
> 
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist