Multisensor 6

[Mark Johannessen]

I haven't been able to straighten this out either.  For some reason I
am getting 16 units for 2 multi sensors with dups with addresses like
"49.TEMP" and the the address of "50" all for the same temperature
sensor (although there may be an issue with deleting units from the
Master List that don't really get deleted - and reappear when Vera
units repopulate Xtension).

Also, I'm not real sure about how the motion sensor on these things
should be working - when its armed in the Vera web interface, the
tripped sensor goes from "clear" to "ALERT" and stays on ALERT and
does not respond to further motions, unless turned off in Xtension.
Maybe others using this have got something to say.

Mark

On Mon, Feb 15, 2016 at 3:02 PM, Charles Pendleton
<charlie at pendletonweb.com> wrote:
> Has anyone had any real success with the 6-in-1 sensor?  I can get it to add
> but it doesn’t seem to be very responsive (takes a long time for the initial
> updates then acts like its not configured properly.
>
> I performed the following;
>
> Reset the device - held the button down for 20+ seconds.
> Put the Vera Edge in include mode, then pressed the button on the Aeon (they
> both did their light dance and 4 devices were created (motion, lumens,
> humidity and temp).  There is no vibration or UV (the Vera is running the
> latest UI7).
>
> Tried deleting and re-adding it but to no avail.  At this point only working
> in the Vera UI and not even trying to get the units over to Xtension.
>
> Thanks,
> Charlie-
>
>
> On Oct 28, 2015, at 10:26 PM, Mark Johannessen <mfjlaw at gmail.com> wrote:
>
> Vera published an update that provides support for the Aeotec Multisensor 6
>
> http://support.getvera.com/customer/en/portal/articles/2172118-vera-beta-software-update-%E2%96%BE-ui7-%E2%96%BE-version-7-0-12-1-7-707-1-7-1509-%E2%96%BE-october-23-2015
>
> Still doesn't look like the vibration sensor is working though
>
> Xtension picks up the motion sensor, lums, and temp OK - but not the UV or
> humidity - f there is no drop down for these options in the Edit Unit device
> selection - will these be added?
>
> Mark
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist
>
>
>
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist
>