testing vera version for multi units and Philippe

[Philippe SCHMUCK]

It works!
I have now, for every Z-Wave power plug that sends power measurement, both id.WATTS and id.KWH created.

Thank you!

Philippe

> Le 14 sept. 2015 à 18:12, James Sentman <james at sentman.com> a écrit :
> 
> Morning Folks,
> 
> Those of you with Vera multi-units like Henk’s that are not sending all their data through to XTension, please give this build of the vera interface a try:
> 
> https://dl.dropboxusercontent.com/u/547252/vera.isf.012.zip
> 
> I believe that this will properly create the main unit for the motion sensing, and then create separate units for the temp, humidity and light data.  It should be generic enough that it will enable those things for other such devices in the future if we’re lucky.
> 
> I also think I figured out what I wasn’t sending for the watts and kwh units that caused it to blow up for for Philippe, so please try again with this build too.
> 
> That is just the interface in that link, not the whole program so you have to do the dance to install it:
> 
> It is not necessary to quit XTension, but you must disable any Vera interfaces that you may have running.
> 
> Control click on XTension in the finder and select “show package contents” open the Contents folder and then the Pitchers folder.
> 
> Remove the current “vera.isf” folder to the desktop or other place so you can put it back in if this version causes more trouble than it fixes. 
> 
> Place the folder you downloaded from the link above into it’s place. Re-enable the interface and let me know what happens.
> 
> 
> Thanks,
> 	James
> 
> 
> James Sentman                       http://sentman.com		http://MacHomeAutomation.com
> 
> 
> 
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist