Need a Window device for Somfy control via Vera

[Mike Andrews]

I can explain, Ryan,

You have it right.

When I say I need the STOP, I mean the "My," which is the same button.
You do program the motor itself to not only know your preferred "My"
position, but the upper and lower limits.
There is no need to time sending of the STOP to get the My preferred
position, if the My position is programmed.
The STOP, as stop!, is good to have otherwise for manual control to choose
a different position.

You also have to do that Add Remote ballet when you add the ZRSTI bridge
for each window/code number.

--Mike


On Sun, Oct 4, 2015 at 2:52 PM, Ryan McLean <mcleanrs-xtension at outlook.com>
wrote:

> James,
>
> Take a look at page "8" of this and see if it helps clear things up:
>
>
> https://www.somfysystems.com/file.cfm/2011_RTS_Pocket_Guide_low.pdf?contentid=204382
>
> Also take a look at page 36 "Setting Intermediate Preferred “MY” Position"
>
> I think there 2 separate preset systems being discussed here. One is the
> "My" button which is a preset stored in the Somfy motor itself. The other
> is any other preset provision that you have read about, with people sending
> a "stop" signal after a preset number of seconds.
>
> The top and bottom limits on the blinds are also set-by-software, so it's
> likely that the motor has some kind of position sensing (Counting rotations
> or something), but unfortunately I don't think the somfy blinds communicate
> 2-way so there would be no way to get that information back out of the
> motor.
>
> _______________________________________________
> XTensionList mailing list
> XTensionList at machomeautomation.com
> http://mail.machomeautomation.com/mailman/listinfo/xtensionlist
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.machomeautomation.com/pipermail/xtensionlist/attachments/20151004/27d49d97/attachment.html>