ActiveEye Sensor

[Thomas Henry]

James, Mike,

Now that I have this thing working, I still have a minor issue.

Using the same living room as an example, I would still lim to be able to use my X1-based remotes to turn the lights on/off. However, doing that activates the motion sensor script, which is not what I want.

What should I be looking at here? Thanks.

Tom

On Oct 20, 2013, at 10:43 AM, James Sentman <james at sentman.com> wrote:

> 
> On Oct 20, 2013, at 9:58 AM, Michael <michael at shed.com> wrote:
> 
>>> I just can't get the script to activate passing by the motion sensor. The sensor does work, as the physical unit is programmed to B1, and turns on the living room light (also set to B1).
> 
> If it turns on the light, also set to B1, without any scripting in XTension then you have a transceiver plugged in that is converting the wireless signal to a wired signal?
> 
> If thats so then you  may not be using a wireless received in XTension at all. In which case you want to set the B1 unit in XTension NOT as wireless, but as a regular X10 wired device. Because once the command goes onto the powerline, regardless of how it got there, it's not a wireless command anymore.
> 
> Perhaps that is the confusion? But we'll have to wait to setup all the rest till we figure out how to get that signal into XTension with your setup.
> 
> Thanks,
> 	James
> 
> 
> James Sentman                       http://sentman.com		http://MacHomeAutomation.com
> 
> 
> 
> _______________________________________________
> XTensionList mailing list
> XTensionList at shed.com
> http://shed.com/mailman/listinfo/xtensionlist